Back Spotface
Use the Back Spotface function to cut out the underside of holes that must be cut through the workpiece.
To program a new Back Spotface operation:
-
Display the Input screen and select the Part Programming softkey.
-
Select the Insert Block Before softkey.
-
Select the Holes softkey. The Hole Operation screen opens.
-
Select the Back Spotface softkey.
This motion sequence occurs with Back Spotface:
-
Rapid to Z Start minus cutter offset and set the spindle speed to a plunge speed.
-
Move to Z Plunge minus cutter offset at a closing feedrate to close the cutter.
-
Rapid to Z Bottom minus cutter offset.
-
Dwell for a specified reverse dwell amount, reverse the spindle direction and ramp to cutting speed to open the cutter.
-
Move up to Z Depth minus cutter offset at a cutting feedrate.
-
Dwell for the drill dwell time (from program parameters).
-
Rapid down a Z Clearance amount.
-
Dwell for the Reverse Dwell time and reverse the spindle direction to plunge speed to close the cutter.
-
Move to Z Retract minus cutter offset at a closing feedrate to insure the cutter is closed.
-
Rapid out of the hole.
See the Field Glossary for definitions of the Back Spotface fields:
|
|||
|
|||
|
|
||
|
|
||
|
|
||
|
|