ATC ERROR – DETECTED TOOL POCKET BOTH UP AND DOWN.
Message is in response to failed steps during either a tool change or a requested action as part of Diagnostics.
Tag Error
DOOR LOCK FAILURE – ENTER CE DIAGNOSTICS AND RESET FAULT.
Door lock failure – enter CE diagnostics and reset fault.
COOLANT PRESSURE IS TOO HIGH. TOOL CANNOT BE UNCLAMPED UNTIL PRESSURE IS CORRECTED.
Coolant pressure is too high. Tool cannot be unclamped until pressure is correct.
SPINDLE FAULT – TIMED OUT WAITING FOR SPINDLE SPEED CHANGE
The spindle did not reach the targeted RPM. Possible causes include an electrical or mechanical issue with the spindle causing it not to reach the targeted spindle speed.
INDEXER NOT INSTALLED OR CONFIGURED PROPERLY.
Indexer incorrect.
ROTARY AXIS CLAMP/UNCLAMP REQUEST FAULT.
A clamping break did not engage or disengage properly. The input was not seen.
{0:A} AXIS UNCLAMP ERROR
A clamping break did not engage or disengage properly. The input was not seen.
{0:A} AXIS CLAMP ERROR
A clamping break did not engage or disengage properly. The input was not seen.
INDEXER IN POSITION 10 SECOND TIME OUT
Indexer position incorrect.
INDEXER POSITION LESS THAN 1
Indexer position incorrect.