The motor temperature measured by the temperature sensor has reached the limit value in “S-0-0204, Motor shutdown temperature”. The drive is immediately decelerated according to the selected error reaction (“P-0-0119, Best possible deceleration”) and shut down. Possible causes: Motor shutdown…
Typically indicates that the chuck sensor is loose or the sensor placement is incorrect.
This error is generated from a Duplomatic TMC turret controller unit. For specific information based on the error code number, select Search Errors/Alarms and set the drop-down menu to Alarm Code. Then search using only the error code number.
Typically indicates an incorrect chuck device type was set for the machine or the chuck sensor needs realignment.
The model generated by this program is too large/complex for the device memory.
Internal fault
During machine calibration, each axis travels to its respective limit switches (the positive or negative limit switch is determined by parameter ________).The axis will stop when the limit switch input is detected by the software. A second limit switch signal is sent to the axis servo drive amplifier which will also stop the axis movement.
During axis motion, the servo drive amplifier outputs a motion signal to the servo motor. Feedback from the encoder or the linear scale is received by the servo drive amplifier.
During spindle motion, the spindle drive amplifier outputs a command to the spindle motor to rotate the spindle. Feedback from the spindle encoder is received by the spindle drive amplifier.
During spindle motion, the spindle drive amplifier outputs a command to the spindle motor to rotate the spindle. On spindle drive amplifiers that have a low and high winding, the winding is automatically determined by the spindle speed command. Note that parameter ________ determines the spindle speed that the winding change occurs.