ATC FAULT – ATC DOOR DID NOT OPEN.
The ATC did not detect the ATC door sensor in the time allotted. Typically caused by a loss of air pressure to the door or debris obstructing the door.
Category Error Text
ATC FAULT – X,Y AXES MOVE FAILED.
Failed to move to tool change position. Typically a secondary error.
ATC FAULT – Z AXIS MOVE FAILED.
Failed to move to tool change position. Typically a secondary error.
HYDRAULIC PUMP TIMEOUT FAULT!
LUBE SYSTEM FAULT – CHECK CONFIGURATION!
SPINDLE SPEED FAULT SENSED – NOT AT COMMANDED SPEED!
Spindle speed fault sensed – not at commanded speed.
A SERVO ERROR OCCURRED DURING TOOL FIXTURE SEQUENCE. (RESET SERVO’S TO CLEAR ERROR)
A servo error occurred during tool fixture sequence.
A FAULT OCCURRED DURING TOOL CHANGE! VERIFY ATC MAP AND TOOL IN SPINDLE.
The system is unsure what tool is in the exchange or ATC pocket. Typically occurs after a primary ATC fault.
SPINDLE OVERLOAD DETECTED – RESET SERVOS AND SPINDLE DRIVE.
The maximum load on the spindle exceeded the rated limit. Typically caused by an application that is demanding more power than the motor can provide.
SPINDLE READY SIGNAL NOT DETECTED.
Spindle Ready signal not detected.