Recovery and Restart

Restart a part program at almost any point within the program - typically, the point at which the running program was interrupted.

If the Emergency Stop button was used to stop machining, machine power must be restored before restarting the program.

To restart the program, follow these steps:

1. Select the console Auto button. The Start Block default is 1, and the End Block default is the last block of the program.

2. Enter the proper Start Block and, optionally, an End Block if other than the end of the program.

3. Select the Recovery Restart softkey.

4. If the Start Block contains multiple choices for restart, prompts are displayed to select the proper point of restart.