W

Warm-Up Axis Feed Rate

—Sets the axis feed rate for each step of the warm-up cycle. See Machine Parameters – Calibration and Warm-up in Getting Started with WinMax Mill for more information.

Warm-Up Cycle Time Per Pass

—sets the time for each step of the warm-up cycle. See Machine Parameters – Calibration and Warm-up in Getting Started with WinMax Mill for more information.

Warm-Up Max Spindle Speed

—sets the spindle speed for the final step of the warm-up cycle. See Machine Parameters – Calibration and Warm-up in Getting Started with WinMax Mill for more information.

Warm-Up Speed Steps

—sets spindle speed increments for each step of the warm-up cycle. See Machine Parameters – Calibration and Warm-up in Getting Started with WinMax Mill for more information.

Warm-Up Starting Speed

—sets the spindle speed for the initial step of the warm-up cycle. See Machine Parameters – Calibration and Warm-up in Getting Started with WinMax Mill for more information.

Warn Before Saving in Old Format

—select Yes to display a warning message when a program is about to be saved in the HD3 file format, which may not support some conversational features.

Washdown Off Delay Timer

—the time the washdown coolant pump is off; used with Washdown On Delay Timer. See Machine Parameters – General 1 in Getting Started with WinMax Mill for more information.

Washdown On Delay Timer

—the time the washdown coolant pump is on; used with Washdown Off Delay Timer. See Machine Parameters – General 1 in Getting Started with WinMax Mill for more information.

Way Lube Status

—indicates Level OK or Low Level. A Low Level alarm will not allow programs to start running.

Width

—the width of the slot. The slot width determines how far to expand the centerline or center arc segment programmed in the Geometry tab. Half of the programmed width is applied to each side of the line or arc.

Width Method

—in Stick Lettering Along Contour, the method of determining the width of the text:

• Use Contour—the text will be distributed evenly along the contour.

• Specify Width—specify the width measurement in the Text Width field (appears when Specify Width is selected).

Write Protection

—prevents changes to the program from being saved when set to ON. Changes can be made if set to OFF.