- Special case for MPx16: Firmware upgrade to higher firmware version. This error occurs once at first start of drive after firmware upgrade.
- Control section configuration not allowed, because an optional module is not supported by firmware
- Firmware used is not suitable, i.e. hardware and firmware do not match
- Hardware defect on control section
Search Errors / Alarms
Alarm Search Result for: 33024
8100
Error When Initializing the Parameter Handling
Description:
- According to instructions, put drive into ready-for-operation status again (see Application Manual ‘Firmware Replacement’). Drive can only be switched to operating mode again after control voltage once was switched off and on again.
- Switch drive off and on again. If error occurs again, replace control section by different control section with appropriate configuration. If necessary, contact our service department
- Select suitable firmware by means of Functional Description or Version Notes / Release Notes (see index entry ‘Supported control sections’)
- Switch drive off and on again. If error still occurs, contact our service department and, if necessary, replace control section or entire drive controller
Drive Type:
RexRoth